Note / Recommended Calibration Values - ProMinent DULCOTEST DT1 Notice D'emploi

Calibration Mode
Note
Separate calibration of the measuring ranges for chlorine dioxide,
bromine and ozone is not possible. The unit uses the calibration
for the chlorine measuring range. Factor of 1.9 is used to calculate
chlorine, factor 2.25 is used to calculate bromine and factor
0.67 is used to calculate ozone, respectively, from the chlorine
polynomial.
Factory calibration active.
CAL
Calibration has been set by the user.
cAL
Recommended calibration values
Chlorine:
pH:
Cyanuric acid: between 30 and 60 mg/l
between 0.5 and 1.5 mg/l
between 7.6 and 8.0
24