Unpacking Of The Unit; Method Of Operation - Dantherm CDT 22 Manuel D'utilisation

ENGLISH
1.

Unpacking of the unit

To avoid damage to the packaging the CDT 22 has to be lifted vertically out. The CDT 35, CDT 35S,
CDT 50 and CDT 85 can be rolled out after having tilted the packaging.
The handle is fitted in accordance with the enclosed description.
2.

Method of operation

The dehumidifiers type CDT work in accordance with the condensation principle.
Figure 2 shows the principle in the cooling circuit.
The humid air is drawn in by a fan (7). The air
passes through a filter and is cooled down on the
evaporator (2). This will bring the air temperature
down below the dew point, which makes the water
vapour condense to droplets on the evaporator.
The droplets fall onto a condensate tray and are led
to a water container or to a drain.
The cold air is then led through the condenser (3)
where it is reheated. This heat comes from the con-
densation process and from the compressor (1) and
fan (7) energy, which is turned into heat. Therefore
the air leaves the dehumidifier at a temperature that
is higher than at the entrance.
The approx. increase in temperature is 5°C.
The continuous air circulation through the unit reduces the relative humidity giving rapid but gentle
drying.
CDT 22
Figure 1 shows the unit in the packaging.
CDT 35, CDT 35S, CDT 50 & CDT 85
Figure 2 shows the principle of the cooling process.
10