Changing The Contact Points Of Eyenimal Training Pulse Collar; Getting The Best Results - Num'axes EYENIMAL Training Pulse Guide D'utilisation

Changing the contact points of EYENIMAL Training Pulse collar


Two different series of contact points are supplied with the EYENIMAL Training Pulse collar.
The length of the contact points must be sufficient to have proper contact with the dog's skin, enabling the
device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
How to check that your EYENIMAL Training Pulse collar is functioning properly

You can check that your EYENIMAL Training Pulse is operating correctly at any time.
- Before doing so, make sure the receiver collar is turned "Off" (indicator light off).
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the test lamp under the contact points).
- Turn "On" the remote control and receiver collar.
- Check the functions of the product as follows:
- when you press the
- when you press the
- when you press the V V V button, the collar must vibrate for as long as the button is pressed
(but 8 seconds max).
- when you press the S button, the neon test lamp must light
- Before disconnecting the test lamp, make sure the receiver collar is turned "Off" (indicator
light off).

Getting the best results


The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves.
These radio waves are sensitive and the range reaches approximately 200 meters (depending on geography
and environment).
The performances of your EYENIMAL Training Pulse will be optimal if you respect the following
recommendations:
- To obtain a good radio range, do not cover the part located above the indicator lights when you hold the
remote control in your hand.
- The position of the receiver collar around the neck of the dog should be in the following way: the On/Off
indicator light is visible and is not in contact with the breast of the dog.
Gb - 24
button, the collar must emit beep sounds
, the high luminosity LED in the collar must light