Safety Features; Changing The Contact Points - Num'axes Canifugue Mix FUG1033 Guide D'utilisation

•

Safety features

The pet fencing system comes complete with 3 safety features:
• wire break alarm
If the antenna wire breaks or if a connection fails, the transmitter will alert you to this operating default:
− the transmitter will emit continuous beep sounds
− the LCD screen will flash
− a symbol will flash on the screen (ref. Diagram 2)
• warning zone evacuation feature
After 20 seconds of continuous presence in the warning zone, your dog will be signalled to leave the zone by the emission of
a few short stimulations (stimulation level depending on the selected mode).
• stimulation zone evacuation feature
If your dog remains in the stimulation zone for more than 20 seconds, the receiver collar stops emitting stimulations. The
normal functioning resumes when your dog leaves this zone.
• Checking and replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
− flashes slowly green: battery sufficiently charged
− flashes quickly red: weak battery. Be prepared to replace battery.
Replace the battery by following the procedure indicated above (see § Fitting the battery in the receiver collar).
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new purchased
product. Other brands of batteries may not operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
After the battery replacement, the collar will operate according to the last selected mode.
Due to greater use during your dog's training, the first battery may not last as long as replacement batteries. Battery life
depends on how often your dog tests the boundary.
•

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact
with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace
them with the long ones supplied with the kit. Carefully tighten them manually (do not use a key).
guide canifugue MIX FUG1033 IndB.indd 32
32
02/04/2019 11:01