Changing The Contact Points - Num'axes CANICALM First Guide D'utilisation

- Retighten the battery cover using a coin. A beep sound is emitted indicating the collar is ready
for use. If you do not hear any beep sound when retightening the battery cover, remove the
battery immediately from its housing. Check the polarity before trying again.
NOTE : when changing the battery, there can remain some power in your collar. In that case, the
collar does not emit any beep sound when you retighten the battery cover after inserting the battery.
To make sure it operates correctly and that the battery is correctly installed, see § Checking the
device operates properly.
Due to greater use during your dog's training, the first battery may not last as long as replacement
batteries.

Changing the contact points


Two different series of contact points are supplied. The length of the contact points must be sufficient
to have proper contact with the dog's skin, enabling the device to operate correctly (proper barking
detection and correct transmission of the stimulations).
If you have a long-haired dog and the short contact points fitted to the collar in the factory are
inadequate, remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
Checking the device operates properly

You can check that your collar is functioning properly at any time using the following procedure:
- Before doing so, make sure the collar is turned Off (battery removed from its housing).
- Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and
retightening them so as to pinch the test lamp wires under the contact points).
- Turn On the collar (battery in place - Warning : after activating the collar, it remains in stand-
by for 2 minutes).
- Make a streaked object (ex. knife with teeth and isolated sleeve) slide on the bark detection
contact point (ref. Diagram 1).
- The collar should emit beep sounds and the test lamp should light.
- Before disconnecting the test lamp, make sure the collar is turned Off (battery removed from its housing).
Gb - 14