Safety Information; Set-Up; Electric Hook-Up; Secure Vessels On Shaker Plate - Heidolph TITRAMAX 100 Mode D'emploi

E
Please comply with all safety and accident-prevention regulations as in force
for laboratory work!
Use extra care when working with flamable substances; refer to safety data
sheets.
Use extra care when working in the vicinity of flammable and explosive
substances. Motors are non-sparking , the item itself however is not
explosion-proof.
When connecting your item with your local power supply, please make sure
your item is designed for your local voltage; refer to the data plate on the item.
Please connect your unit with a protective-ground outlet only.
Turn your power switch OFF whenever the item is not used, or before
disconnecting the plug.
Repair work is limited to technicians approved by Heidolph Instruments.
Your item needs a solid stand.
Lab bench needs to be of rigid design, and have an anti-skid surface coat.
Before starting the item, make sure all vessels are attached safely (must not
move while shaking).

1. Set-up

Please locate the shaker on a stable, horizontal surface. For safety reasons, keep the area
around the machine clear of other items.
Be aware of orbital movement of the shaker plate and vessel set-ups protruding over the
standard table surface.

2. Electric hook-up

Use the power cord from your hardware bag and connect it with the plug connector in the
item's rear panel.
The item features two-pole circuit breakers located in the item's plug connector for ease of
access. For circuit breaker details refer to data plate.
3.

Secure vessels on shaker plate

Use optional adapter to secure vessels on shaker plate. Adapters with clamping rollers for a
variety of flasks, beakers, and test tubes are available. Microtiter plates nest on the shaker
plate, no optional holders are required.
In special cases, and at low shaking speed, e.g. Petridishes may be placed on the anti-skid
rubber plate that comes with your item as a standard option.

SAFETY INFORMATION

SET-UP
16