Perma CLASSIC Instructions De Service page 13

♦
Write the activation and exchange date on the label of the perma CLASSIC.
♦
Remove cap from the opening.
1
♦
Tightly screw the lubricator into the
lubrication point by hand.
Detailed information about special installations can be obtained from the
installation guidelines of perma CLASSIC-FROST-FUTURA which can be
ordered from your local supplier.
3. Discharge period perma CLASSIC
Activator screw
(color code/part name)
Avg. temperature
Avg. temperature +10 °C/ 50 °F
Avg. temperature +20 °C/ 68 °F
Avg. temperature +30 °C/ 86 °F
Avg. temperature +40 °C/104 °F
(Time required until fi rst lubricant discharge takes place - without counter pressure)
chart 2
This table is based on tests conducted by perma-tec under laboratory conditions and
should only be used as a general guideline for selecting the discharge period.
The actual discharge period is strongly infl uenced by various factors like type of
lubricant, ambient temperature, vibration and connecting parts (e.g. tubes).
perma CLASSIC should not be unscrewed from the lubrication point during the
discharge period as this would cause pressure loss inside the lubricator.
- 9 -
Discharge periods (discharge volume 120 cc in months)
0 °C/ 32 °F
Initial delay ≙ aprox. 1 day
5
picture 4
6
picture 5
yellow green
1 month 3 months
4 8
2 5
1 3
0,8 2
0,6 1
perma CLASSIC
red grey
6 months 12 months
15 > 18
8 18
6 12
3 6
2 3