Special Product Features; Operating Elements - Metabo TKHS 315 C Instructions D'utilisation Originales

ENGLISH
The board should be 400 mm long, at
least 200 mm wide and 15 – 20 mm
high.
The push block handle must be re-
placed if damaged.
50
5. Special Product Fea-
tures
– Steplessly adjustable bevel tilt from
0 to 45.
– Stepless depth of cut setting to
85 mm.
– An undervoltage relay prevents the
power tool from starting up when
power is restored after a power fail-
ure.
– All operating elements are located
at the machine's front.
– A rear table extension is standard
delivery.
– Robust sheet steel construction –
high load-bearing capacity and per-
manent protection against corro-
sion.
6.

Operating elements

ON/OFF switch
To start = press green switch button

(52).
To stop = press red switch button

(53).
52
53
24
Note:
In case of a power failure an undervolt-
age relay trips. This prevents the power
tool from starting when the power is re-
stored. To restart, press the green
switch button again.
51
Setting device for saw blade tilt
The saw blade tilts steplessly between
0 and 45.
To keep the set angle of inclination
from changing when sawing it is locked
by means of two handwheels (54) at
the front and rear of the chip case.
Crank for cutting height adjustment
The cutting height is adjusted by turn-
ing the crank (55).
Fences
The saw is equipped with a universal
fence, which can be used as mitre
fence or rip fence:
Mitre fence (for cross-cuts / mitre

cuts):
58
57
54
55
59
56
To be used as mitre fence the uni-
versal fence is installed on the
guide extrusion at the left side of the
saw table.
– Knob (56) for mitre angle setting.
The setting range is 60. When
sawing with the mitre fence knob
(56) must be firmly tightened.
– Knob (57) for sliding function.
When sawing with the mitre
fence knob (57) must be loos-
ened.
– Knurled nuts (58) for fence extru-
sion position adjustment. The
plastic lug (59) of the fence ex-
trusion shall have at least 10 mm
distance to the line of cut.
Rip fence (for ripping):

60
To be used as rip fence the univer-
sal fence is installed on the guide
extrusion at the front of the saw ta-
ble.
– For ripping the fence extrusion
(60) must be parallel with the
saw blade and locked in position
by knob (61).
– Knob (62) for sliding function.
When sawing with the rip fence
knob (62) must be firmly tight-
ened.
– Knurled nuts (63) for attaching
the fence extrusion. After loosen-
ing the two knurled nuts (63), the
fence extrusion can be removed
and shifted:
64
63
Small edge (64) :
– for cutting thin stock.
– when the saw blade is tilted.
62
61
65