Special Product Features; Machine Details - Metabo KGT 300 Instructions D'utilisation Originales

Do not reach into the run-
ning saw blade.
Wear safety goggles and
hearing protection.
Wear dust mask.
Do not operate machine in
moist or wet environment.
Do not carry machine
at the handle; the
handle
designed to bear the
weight
machine.
Information on the nameplate:
23
24
25
26
27 28
29
23 Manufacturer
24 Serial number
25 Machine designation
26 Motor specifications (see also
"Technical Specifications")
27 Date of manufacture
28 CE-mark – This machine con-
forms to the EC directives as per
Declaration of Conformity
29 Waste disposal symbol – the
machine can be disposed of
through the manufacturer
30 Dimensions of permissible saw
blades

4. Special Product Features

− Qick change over from crosscut saw
mode to table saw mode.
− 93° cutting angle range for bevel
cuts (48° left through 45° right) with
five preset stops.
− 110° cutting angle range for mitre
cuts (50° left through 60° right) with
ten preset stops.
− Perfect for mobile use because of its
low weight and small dimensions.
− Sturdy cast aluminium construction
for precision cuts.
− TCT saw blade.
− Unproblematic saw blade change by
saw blade lock; no dismounting of
the retractable blade guard required.
− Installation of auxiliary fence possi-
ble.
− Convenient continuous table heigt
adjustment.
− Sturdy three-point support of the
upper saw table.
− Overload protection by automatic
cutoff.
− A restart protection prevents restart-
ing of the machine when the power
is restored after an interruption of
the power supply.
is not

5. Machine Details

of the
3
Note:
In this chapter the essential oper-
ating elements of the machine are intro-
duced.
The proper use of the saw is detailed in
chapter "Operation". Read this chapter
before using the saw for the first time.
ON/OFF switch
•
To turn the motor ON:
Press on the upper half of the ON/
OFF switch button(31).
30
•
To turn the motor OFF:
Press on the lower half of the ON/
OFF switch button.
Rotating table
The rotating table turns through 50° to
the left and through 60° to the right and
engages in preset stops at the 0°, 15°,
22.5°, 30°, 45° and 60° position.
For turning the rotating table the lock
screw must be loosened.
A
Caution!
In order to prevent the mitre
angle from changing during cutting,
the rotating table's lock screw must
be tightened (also when the table is
engaged at the preset stops!).
31
Bevel tilt setting
The track arm holder can be tilted from
vertical through 48° to the left and
through 45° to the right; it engages in
preset stops at the 0°, 22.5° and 45°
position.
ENGLISH
21