Metabo TKHS 315 C Instructions D'utilisation Originales page 26

ENGLISH
3. Push one end of the suction hose
(78) on the blade guard's suction
port (79).
4. Fit other end of the suction hose to
the dust extraction port (80) on the
chipcase.
5. Hook the suction hose into the hose
carrier (81).
6. Connect the saw's dust extraction
port at the chipcase to a suitable
dust collector (see 'Dust collector' in
chapter 'Operation').
79
81
80
Guide extrusion installation
Item Description
82 Hexagon head screw
M6 x 16
83 Guide extrusion,
short
84 Guide extrusion,
long
85 Washer 6.4
86 Hexagon nut M6
1. Slide two each hexagon head
screws (82) with the heads into a
guide extrusion.
2. Guide extrusion locations:
– short guide extrusion (83) at the
front of the saw table;
– long guide extrusion (84) at the
left-hand side of the saw table;
26
3. Adjust position of the guide extru-
sions so that the countersinking of
the extrusions will accommodate
the hexagon head screws of the
78
legs.
4. Put one each washer (85) from in-
side on the hexagon head screw,
then secure with hexagon nut (86).
Installing the table extension
Item Designation
87 Extension plate
89 Washer 6.4
90 Locking nut M6
92 Bearing screw
M6 x 35
91 Support
93 Hexagon nut, self-
95 locking M6
94 Hexagon screw
96 M6 x 16
88 Angle
Qty.
A
4
Caution!
When installing the rear table exten-
1
sion, both panel and support struts
need to be held as long as they are
1
only bolted to one end.
4
1. Unscrew and remove the 4 hexagon
4
screws at the rear side of the frame.
2. Push the angles (88) onto the axles of
the extension plate (87) and screw to
the frame using the previously removed
hexagon screws.
82 86 85
83
84
Number
1
2
2
2
2
2
2
2
87
88
3. Attach each of the supports (91)
with one bearing bolt (92), one was-
her (89) and one flange nut (90) to
the table extension (see illustration).
89 90
92
91
4. Tighten all bolted connections of the
table extension hand-tight using a
suitable tool.
3
Note:
The supports of the table extensions
can be fixed securely in place. Alterna-
tively, they can be installed in such way
that the table extension can swing
down.
Stationary support installation
1. Insert the offset ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside.
2. Fasten each of the supports with
one countersunk screw (94) and
one prevailing torque-type hexagon
nut (93) to the strut as illustrated.
94
93