Special Product Features; Operating Elements - Metabo PK 255 Instructions D'utilisation Originales

ENGLISH
Handle for push block
The handle for the push block (38) is
screwed to a matching board (37). It is
used for safe guidance of relatively
small workpieces.
The board should be between 300 and
400 mm long, 80 to 100 mm wide and
15 to 20 mm high
The push block handle must be re-
placed if damaged.
37
5. Special Product
Features
– Stepless tilt angle adjustment from
0° to 45°.
– Stepless depth of cut setting to
80 mm.
– All operating elements are located
at the machine's front.
– Aluminium table top and fences –
for precise cuts.
– Torsion-free sheet steel machine
enclosure.
– Table extension is standard delive-
ry.
– Can be extended for a wide range
of applications.
– Sawdust-tested in compliance with
TRGS 553 by FPH.
6.

Operating Elements

ON/OFF switch
 To start = press green switch button
(40), .
 To stop = press the red switch but-
ton (39) or the cover (41) of the ON/
OFF switch.
26
38
The ON/OFF switch can be additionally
secured with a padlock.
3
Note:
In case of a power failure an undervol-
tage relay trips. This prevents the po-
wer tool from starting when the power
is restored. To restart, press the green
switch button again.
Handwheel for tilt angle adjustment
The saw blade can be steplessly adju-
sted from 0 to 45 with the handwheel
(42).
3
Note:
The pivot is at the same height as the
saw table so that the cutting depth re-
mains constant for all tilt angles.
For the set tilt angle to remain un-
changed during sawing it must be fixed
with the locking lever (43).
If the locking lever does not have a suf-
ficient swivelling range for adjustment it
can be repositioned:
 Pull out the locking lever, turn and
39 40
re-engage.
41
Handwheel for setting the depth of
cut
The cutting depth can be adjusted
through turning of the handwheel (44).
Fences
The saw is equipped with two fences.
Mitre fence (for cross-cuts / mitre cuts):
The mitre fence can be inserted into the
slot in the sliding carriage or the slot
(48) in the saw table.
The fence extrusion can be swivelled
45° both ways for mitre cuts.
– Locking lever (47) for fixing the ang-
42 43
le.
– Knurled nuts (45) for fence extrusi-
on position adjustment. The plastic
lug (46) on the fence extrusion must
point towards the saw blade at a mi-
nimum distance of 10 mm to the
saw blade.
44
45 46 47
48