Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Motor does not run
Undervoltage relay tripped by power
failure:
– switch on again.
No mains voltage
– check cable, plug, outlet and mains
fuse.
Motor overheated, e.g. by a blunt saw
blade or chip build-up in the chip case:
– remove cause for overheating, wait
for a few minutes, then start saw
again.
Motor supply voltage too low:
– use a shorter supply line or a supply
line with a larger cross section
2
( 1.5 mm
).
– have power supply checked by a
qualified electrician.
Loss of cutting performance
Saw blade blunt (possibly tempering
marks on blade body):
– replace saw blade (see section
'Care and Maintenance').
Saw dust build-up
No dust collector or dust collector of in-
sufficient capacity connected (see
"Dust collector" in chapter "Operation"):
– connect dust collector, or
– increase suction capacity.
Height adjustment mechanism of
saw blade working stiff
Spindle of height adjustment mecha-
nism gummy:
– clean spindle and spray with Care
and Maintenance Spray (see chap-
ter "Care and maintenance").
ENGLISH
33
Publicité
Chapitres
Table des Matières
