Metabo TKHS 315 C Instructions D'utilisation Originales page 27

Support installation for folding down
of table extension
1. Attach one countersunk screw (96)
and one prevailing torque-type he-
xagon nut (95) to the lower end of
each of the struts.
2. Insert the lower ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside (see illu-
stration).
96
Tightening the screwed connections
Check all screwed connections of

the saw. Tighten all screwed con-
nections hand-tight with a suitable
tool.
Observe the following when tighte-
ning the screws:
– The machine must stand firmly
and levelly after the screws have
been tightened.
– Adjusting the table extension: the
table extension's surface must be
parallel with and in the same pla-
ne as the top of the saw table.
Swinging the table extension down
1. Slide the lower ends of the supports
towards each other.
2. Lift supports out of the strut and
swing table extension down as illu-
strated.
Wheel set installation
Item Description
97 Wheel set
98 Hexagon head screw
M6 x 16
99 Washer 6.4
100 Hexagon nut M6
The wheel set attaches to the rear legs
of the saw.
1. Each of the wheel set brackets (97)
must have two hexagon head
95
screws (98), with washers fitted (99)
put through it from the rear.
2. From inside put on washers (99)
and screw on hexagon nuts (100).
3. Adjust position of brackets so that
the wheels are approx. 1 mm above
the floor when the saw is standing
on all four legs.
98
97
4. Tighten hexagon nuts.
Transport handle installation
Item Description
101 Transport handle
102 Hexagon head screw
M6 x 16
103 Washer 6.4
104 Hexagon nut M6
The transport handles are installed on
the front legs of the saw.
1. From the front put through each
transport handle
head screws
(103)
Qty.
1
4
8
4
99
100
Qty.
2
4
8
4
(101)
two hexagon
(102)
with washers
fitted.
ENGLISH
104
2. Install transport handles in such
way that the tubes can be folded
down.
3. From inside put on washers
and screw on hexagon nuts
Accessory holder installation
Item Description
105 Hexagon nut M6
106 Screw hook M6
107 Washer 6.4
In a final assembly step two screw
hooks are installed on the sides of the
front legs to serve as accessory holder:
1. Turn one each hexagon nut (105)
about 10 mm up the thread of the
screw hook (106).
2. Put a washer (107) on the screw
hook.
3. Put hook through the hole provided
in the leg and secure with one each
washer (107) and hexagon nut
(105).
105
106
Tightening the screwed connections
Check all screwed connections of

the saw. Tighten all screwed con-
nections hand-tight with a suitable
tool.
103
102
101
(103)
(104)
.
Qty.
4
2
4
107
27