Special Product Features; Machine Details - Metabo KGS 303 Plus Instructions D'utilisation Originales

2. Lower the sawhead and push the
transport locking pin (39) in.
3. Keep the packing for future use, or
separate by material and dispose of
in an environmentally friendly man-
ner.

5. Special product features

− 96° cutting angle range for bevel
cuts (48° left thru 48° right) with five
positive stops.
− 110 ° cutting angle range for mitre
cuts (50 ° left thru 60 ° right) with ten
positive stops.
− Soft start.
− Integrated cutting depth stop for
grooving.
− Perfect for mobile use because of its
low weight and small dimensions.
− Precise and sturdy die-cast alumin-
ium construction.
− TCT saw blade.
− Unproblematic saw blade change by
saw blade lock; no dismounting of
the retractable blade guard required.
− Maximum dept of cut 81 mm.
− The track arm provides for up to
300 mm cutting width.
− Ergonomic control for both left-
handers and right-handers.
− Installation of auxiliary fence possi-
ble.

6. Machine details

3
Note:
In this chapter the essential oper-
ating elements of the machine are intro-
duced.
The proper use of the saw is detailed in
chapter "Operation". Read this chapter
before using the saw for the first time.
ON/OFF switch
•
To turn the motor ON:
Press and hold the ON/OFF switch
(41).
•
To turn the motor OFF:
Release the ON/OFF switch.
Rotating table
For mitre cuts the rotating table (42),
after loosening the locking screw (43),
can be turned by 50° to the left and 60°
to the right.
The rotating table engages at positive
stops at the 0°, 15°, 22.5°, 30°, 45°, and
60° position.
A
Caution!
In order to prevent the mitre angle
from changing during cutting, the
rotating table's locking screw must
be tightened (also when engaged at
the positive stops!).
Push/pull action
The track arm permits the cutting of
workpieces having a larger cross sec-
tion. The track can be used for all type of
cuts (standard cross cuts, mitre cuts,
41
bevel cuts, compound mitre cuts).
When it is not required, arrest the track
arm with the locking screw (44).
42 43
Cutting depth limiter
Together with the track arm, the cutting
depth limiter (45) makes grooving possi-
ble.
Hinged fence
The hinged fence (46) permits the saw-
head to tilt up to 48° to the right for bevel
cuts.
A
To provide firm support for the work-
piece (as much supporting area as
possible), the hinged fence is to be
used as under:
•
Sawhead tilted between 22.5° and
48° to the right: loosen screw (47)
ENGLISH
44
45
47
Caution!
46
21