Assembly - Metabo TKHS 315 C Instructions D'utilisation Originales

Wide edge (65) :
– for cutting thick stock.
7.

Assembly

Danger!
Modifications to the saw or use of
parts not tested and released by the
manufacturer can lead to unforeseen
damage during operation!
– Assemble the saw in strict ac-
cordance with these instructions.
– Use only the parts supplied as
standard delivery.
– Do not change any parts.
Only if you follow the instructions exact-
ly does the saw conform to the safety
regulations and can be safely operated.
If you also observe the following notes,
the assembly will cause no problems:
Read the instructions for each step

before executing it.
Lay out the parts required for each

work step.
Required tools
– Two 10 mm wrenches
Stand assembly
Item Description
66 Leg
67 Hexagon head screw
M6 x 16
68 Washer 6.4
69 Hexagon nut M6
70 Hose carrier
71 Stanchion, long
72 Stanchion, short
1. Place table panel, motor facing up,
on a stable support.
Caution!
Saw blade and riving knife must not
rest on the support! To prevent dam-
age to the saw or support, the table
panel should be placed onto two
sawhorses.
2. Attaching the four legs (66) to the
inside of the table panel's corners:
– Put hexagon head screws (67)
with washers (68) fitted through
from the outside;
– from the inside put on washers
(68) and screw on hexagon nuts
(69) – do not fully tighten yet.
3. At the location indicated by an ar-
row attach the hose carrier (70),
with the opening to the rear, to the
saw table.
66
71
70
4. Fit long stanchions (71) between
the side legs and short stanchions
Qty. (72) between the front and rear
legs:
4
– the wide sides of the stanchions
28
face the table panel;
56 – the nibs and recesses must fit
into each other;
28
– Put hexagon head screws with
1
washers fitted through from the
2
outside;
2
– from the inside put on washers
and screw on hexagon nuts – do
not fully tighten yet.
5. Bolting up the stanchions with each
other:
– Put hexagon head screws with
washers fitted through from the
saw table's top side;
– from the underside put on wash-
ers and screw on hexagon nuts
– do not fully tighten yet.
– With the help of another person,
turn the saw over and stand it on
a level floor.
69 68 67
72
ENGLISH
6. Tighten all hexagon head screws
and hexagon nuts of the saw stand.
ON/OFF switch installation
Item Description
73 Hexagon head screw
M6 x 16
74 Washer 6.4
75 Hexagon nut M6
1. Remove the transport lock of the
switch and attach the switch plate
from the inside to the edge of the
saw table:
– Put hexagon head screws (73)
with washers (74) fitted through
from the outside;
– from inside put on washers (74)
and screw on hexagon nuts (75).
75
74
73
Caution!
Make sure the cable does not run over
sharp edges and is not bent.
Installing the dust collection gear
Item Description
76 Blade guard
78 Suction hose
1. Raise saw blade fully.
2. Install blade guard (76) on riving
knife (77).
77
Note:
The blade guard is tilted slightly down-
ward on the operator side after installa-
tion on the riving knife.
Qty.
2
4
2
Qty.
1
1
76
25