Hendi 630402 Mode D'emploi page 5

Changing the cutting plate and push block
• Cutting Plate: Remove two wing nuts, slide off 3/8"
cutting plate and replace with either 1/4" or 1/2"
size cutting plate. Two-hole design allows for cor-
rect placement of Cutting Plate every time. Note:
Do not remove the acorn nuts.
• Push Block (Black): Locate the two thumb screws
on the back of the mounting plate. Remove
Cleaning instructions
1 Be very careful when handling and operating the
fry cutter to keep hands away from the blades.
2 Completely disassemble the Fry Cutter and hand
wash all parts that come in contact with food.
Note: Refer to "Changing cutting plate section on
page 7.
3 Remove Thumb Screws to release PUSH BLOCK.
4 Remove Wing Nuts to release the Blade and
Holder Assembly or Blade Holder and Blade.
5 Remove Thumb Screws and Blade Holder Plate.
6 Clean with warm, soapy water before and after
each use. Rinse with clean water. Dry all parts
completely before re-assembly.
Warranty
Any defect affecting the functionality of the appli-
ance that becomes apparent within one year after
purchase will be corrected by free repair or replace-
ment provided the appliance has been used and
maintained in accordance with the instructions and
has not been abused or misused in any way. Your
statutory rights are not affected. If the appliance is
claimed under warranty, state where and when it
Discarding & Environment
At the end of the life of the appliance, please dispose
of the appliance according to the regulations and
guidelines applicable at the time.
thumbscrews by hand or with screwdriver. Re-
move Pusher block and replace with optional 1/4"
or 1/2" size pusher block. NOTE: Make sure the
pusher block size matches up and fits with the
cutting plate blade grid.
• Replace screws and tighten.
7 Minimize the use of alkaline cleaners as they may
cause pitting and dulling of the finish.
Not dishwasher safe! Hand-wash all parts that
come in contact with food in warm, soapy water be-
fore and after each use. Rinse with clear water. Dry
all parts thoroughly before re-assembly.
It is best to use a food-grade silicone spray or grease
to coat all metal parts before storing.
was bought and include proof of purchase (e.g. re-
ceipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Throw packing materials like plastic and boxes in
the appropriate containers.
EN
5