HumanTechnik lisa Mode D'emploi page 10

When supplied from the factory, all
radio flashing receivers are set to
channel 0. It is only necessary to set
units to other channels if you have
several different users operating
units in the same building.
Set the required channel by using a
small screwdriver to turn the chan-
nel selector switch, which is located
towards the top of the battery com-
partment, to the required channel
number.
All transmitters and receivers must
be set to the same channel.
2. Transmission signal detection
The radio flashing receiver converts the various transmission signals into
different sequences of vibration and lamp signals.
Telephone:
Flashing rhythm
Doorbell I:
Flashing rhythm
Doorbell II:
Flashing rhythm
Babymonitor:
Flashing rhythm
10 English
Telephone LED lights
Doorbell LED lights
Doorbell LED lights
Babymonitor LED lights
➡
Operation –
1. Switching on the unit
Set the on/off switch to on. The
radio flashing receiver is now ready
to operate. After the unit has been
switched on, each of the indicator
lamps lights up briefly in succession
and the receiver vibrates three
times. This forms part of a self-test
of the unit and lets you know that it
is functioning correctly.