Télécharger Imprimer la page

Low Battery Indicator; Memory Wipe; Switching Off/Use As A Non-Selective Cat Flap - SURE petcare DualScan Microchip Cat Flap Notice D'utilisation

Masquer les pouces Voir aussi pour DualScan Microchip Cat Flap:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 67

10. Low Battery Indicator

Batteries last typically for at least 6 months with normal levels of use. When the batteries
are nearing the end of their life, the low battery indicator comes on. This is a slow red flash
of the indicator lamp, once every 5 seconds. The unit will continue to operate when the low
battery indicator is on, however the batteries should be replaced at the earliest opportunity.
Note the slow flash of the lamp (every 5 seconds) for the low battery indicator is different
from the fast flashing (every second) in learn mode. Learn mode should not be used when
the batteries are low – replace the batteries before programming a new microchip or collar
tag into the memory.

11. Memory Wipe

It is very unlikely that you will need to wipe a cat's microchip or collar tag code from the cat
flap's memory. Up to 32 different codes can be stored in memory, and if more additional
codes are learnt these simply replace the earliest ones stored. You can also change a cat's
permissions at any time, as described in section 5.3. However, in the unlikely circumstance
that you need to wipe the memory (e.g. you accidentally programme for next door's cat!),
follow the process below.
1. Press and hold the memory button for at least 10 seconds.
2. The indicator lamp will stay on for the duration that the button is held down.
3. When the memory is wiped, the catch will open and close once.
4. At this point the memory is clear and the cat flap can re-learn your cat(s) microchip
numbers, as required.
12. Switching Off/Use As A Non-Selective Cat Flap
In the event that you want to turn off your DualScan cat flap and revert to using it as a
standard cat flap (so that any cat can exit or enter at any time), follow the four steps below:
1. Remove the battery cover and make sure batteries are installed.
2. Press the memory button once to put the cat flap into learn mode. The catch will open
and the indicator lamp will flash green.
3. Remove the batteries and replace the battery cover.
4. The catch will stay open and the DualScan cat flap can now be used as a standard cat flap.
This mode may be useful if you have purchased the DualScan cat flap before your cat has
been microchipped or while your cat is getting used to the presence of its new cat flap (see
troubleshooting guide). Alternatively, the Sure Petcare RFID Collar Tag is available if your
cat is not yet microchipped.
Note: Keep indoor-only cats out of the room with the cat flap in when operating as a non-
selective cat flap.
20

Publicité

Dépannage

loading