SURE petcare DualScan Microchip Cat Flap Notice D'utilisation page 11

8. Mount the external frame on the outside of the house. Depending on the thickness
of the door, the tunnel will protrude through the frame by differing amounts. Under no
circumstances should you cut or drill through the tunnel as this contains the
microchip reader and will prevent the unit from working properly. Three different
lengths of screw have been provided for your use. Choose the correct screw length to
suit the thickness of your door. If you are not sure, use the smallest first, if this is too
short use the next size up. Take care not to use a longer screw than needed, as this may
damage the main assembly front face. Screw the external frame to the main assembly.
See Figure 10.
9. When the cat flap has been mounted correctly, place the screw caps over the screw
holes on the external frame. Align the screw caps with the slot pointing inwards and push
firmly into place. To remove the screw caps slide a flat blade screwdriver into the side
slot and lever the cap out of the hole. See Figure 11.
Figure 4
Figure 6
Figure 8
Figure 10
Figure 5
Figure 7
Figure 9
Figure 11
11