Petra electric KM 45 Mode D'emploi page 53

5. Close the water tank again with the
tank lid (5).
6. Fill the water tank up to the max mark
(7) with cold tap water through the fill
opening in the tank lid.
7. Place the water tank back into the
machine. The start/stop button
(16) will illuminate in green shortly
afterwards.
8. Ensure that the empty pad cassette
(2) has been pushed in and turn the
adjusting knob (17) to position
Note: The adjusting knob cannot be
set to this position if the pad cassette
has not been pushed in.
9. Place an at least 0.5 litre container in
the middle of the grate
10. Extend the milk tube (19) into the
container.
11. Press the start/stop button .
During start-up, the number of rinsing cy-
cles required is established electronically.
If several rinsing cycles are required, the
process will be aborted every 45 seconds
and the start/stop button will flash green.
If necessary, empty the collecting vessel
and activate the start/stop button (12)
again.
As soon as the appliance has been
sufficiently rinsed, the vaporizer will start
operating.
Do not interrupt the rinsing cycles.
Do not remove the water reservoir
and do not pull out the power plug; other-
wise you will need to restart the start-up
process.
12. Turn the adjusting knob (17) back to
the initial position
start-up has been completed.
.
as soon as the
17
2
19
7
5
16
DE
GB
FR
11