R Signal Button; Using Pause - switel CD728 Mode D'emploi

- Operation -
4.15

R Signal button

If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The "R" signal button gives you
access to these facilities. To do this, press the MORE display button and choose SEND
R and OK during a call.
The FLASH time "120ms" will be required on a private exchange (Adjustment, see 9.3).
You can find out from the dealer from whom the equipment was purchased whether
your telephone will work on your private exchange without any problems.

4.15.1 Using Pause

With private exchanges, it is necessary to dial a certain number (e.g. "9" or "0") in order
to obtain a dialling tone for an outside line on the extension. With some, older private
exchanges, it takes some time before the dialling tone can be heard. Especially for
these private exchanges, an automatic pause can be inserted after connecting to the
outside line so that you can dial directly without waiting for the dialling tone.
Entering a pause when dialling manually
Press and hold the redial button for 2 seconds between the number for the
outside line and the actual telephone number. The letter P will appear in the display.
After connecting to an outside line your telephone will wait for 3 seconds before dialling
the actual telephone number.
The pause can also be saved with numbers in the phone book.
NOTE: If an automatic outside line code is activated, the pause will be inserted
automatically. You will find more information in Chapter 9.6.
115