Care And Maintenance; Maintenance Information; Testing Procedure; Check Of Transducer And Enclosure Acoustic Behavior - L-Acoustics 8XTi Manuel D'utilisation

8 8 8 8 XT XT
XT XT
i COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE
user manual user manual
user manual user manual
VERSION 1.1
8 8 8 8

CARE AND MAINTENANCE

CARE AND MAINTENANCE
CARE AND MAINTENANCE CARE AND MAINTENANCE
8.1

Maintenance information

®
The L-ACOUSTICS 8XTi enclosure is a technical product designed for various, intensive indoor and outdoor sound
reinforcement applications. To fulfill such demanding conditions L-ACOUSTICS
high-grade and reliable components:
•
Weather-resistant transducers.
•
Baltic birch plywood cabinet.
•
Polyester powder-coated steel grill covered by a non biodegradable "Airnet" fabric.
•
Oxidation-resistant screws and rigging points.
However, in order to ensure product performance and safety, it is essential to frequently inspect the 8XTi cabinet and
its internal components. These checks need to be done on a regular basis depending on the conditions of system use.
The testing procedure consists of three steps as described in section 8.2. If a transducer needs to be repaired or
replaced, apply the corresponding procedure in section 8.3.
8.2

Testing procedure

8.2.1

Check of transducer and enclosure acoustic behavior

Connect a sweep frequency generator to the active input of the LA4 / LA4X amplified controller. Apply a sweep from
65 Hz to 20 kHz with a maximum voltage of 0.2 volts (-12 dBu, -14 dBV): the sound should remain pure and free of
any unwanted noise. If not, check the mechanical assemblies and, if necessary, contact an L-ACOUSTICS
representative to repair or replace the damaged components (see also section 8.3).
!
0.2 volts is a maximum value that can generate very high sound levels at given frequencies.
Use ear protection to set the sound level before testing.
WARNING
Whenever a transducer is reconnected, wiring polarity should be checked using a phase checking device. If a transducer
is out of phase, invert the cables connected to its electrical sockets. The connecting procedures are given in section 8.3.

8.2.2 Check of mechanical assembly and rigging parts

Inspect the general aspect of assembly and check that screws are locked tight (on loudspeaker, diaphragm, and grill).
Check the quality of contact and locking action of the Speakon
8.2.3

Check of external aspect

Remove the dust from the grill with a vacuum device. If needed, repaint the cabinet.
If paint is applied, protect mechanical parts.
!
Do not apply paint to the front grill fabric as it could fill the fabric holes and deteriorate the acoustic
transparency of the material.
IMPORTANT
8XTI_UM_ML_1-1
®
sockets.
w w w . l - a c o u s t i c s . c o m
®
has designed the 8XTi enclosure with
®
authorized
16 en 16
16 16