General Information - Westfalia 300 072 300 107 Instructions De Montage

GB
Installation instructions
Electronic system for trailer hitch
Westfalia no.:
Fiat Nr.
Area of application:

General information:

Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical kit may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer, etc.) may be lost.
During trailer towing the rear fog light of the pulling vehicle is switched off by the control unit.
Install a rear fog light on older trailers if they do not already have one before operating this elec-
trical equipment with them.
The failure of a turn signal, including on the trailer, is indicated by an increase in the flashing fre-
quency. As a result, no additional flashing check is required.
An electrical socket adapter may only be used during trailer towing, and must be removed after
trailer towing is completed!
The German version of these installation instructions shall be applicable in the event of a any legal
questions.
Additional information!
Replace fuse 1 (10A) with a 15 A fuse for all vehicles of the Fiat Marea 1999 series or
later.
Subject to changes!
26
7/13-pin
300 072 300 107 and 300 072 300 113
46 216 238 und 46 216 239
Universal electrical system (Top Tronic) for vehicles with-
out Check Control, also with Parktronics