General Information; Installation Instructions - Westfalia 329 057 Notice De Montage Et D'utilisation

Towing hitch
GB
Manufacturer: WESTFALIA-AUTOMOTIVE GmbH
Approval no. as per Guideline 94/20/EC:
Class: A50-X
Technical data:
Used for:

General information:

The vehicle manufacturer's specifications regarding trailer load and nose weight are deci-
sive for driving, and the values specified for the towing hitch must not be exceeded.
The towing hitch serves for towing trailers fitted with ball couplings and for use with load carriers
approved for attachment to the towing hitch. Any use other than that specified is prohibited. Driving
with a trailer must be adapted to the road conditions. The vehicle's handling is affected when a trailer
is being towed. Follow the vehicle manufacturer's instructions.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.

Installation instructions:

The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mat-
ing surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing speci-
fied tightening torques.
The towing hitch must be kept clean and greased. However, if a stabilisation device, e.g.
Westfalia "SSK", is used, the towing hitch must be free from grease. Follow the instructions in
the relevant operating instructions.
As soon as the towing hitch diameter is 49.0 mm or less at any point, it must no longer be used
for safety reasons.
After the towing hitch is fitted, the empty weight of the vehicle increases by 3 kg.
Installation instructions:
Fix the towing hitch on the dead-end transverse girders of the motor vehicle or on the towing
bracket tight with four M 10 screws, property class 10.9, and nuts M 10, property class 10.
Torque: for M 10 55 Nm + 10 %
10
Without electrical set
Model:
Maximum D-value:
Maximum nose weight: 150 kg
motor vehicles with dead-end transverse girders or towing brackets that
show a 56 x 83 mm hole pattern from the factory.
Westfalia order no.: 329 088
e13 00-0100
329 057
13,0 kN
Subject to alteration.