MIRKA CEROS Instructions D'utilisation page 92

en | us • ca
U.S. warranty
The warranty terms are as follows:
2+1 years on KWH Mirka® CEROS electric sanders . Refer to www .mirka-ceros .com or the included warranty card for
complete information on the tool warranty .
The warranty does not include:
• Normal wear and tear.
• Overloading or improper use i.e.
– Dropping the tool in water
– Damage caused by misuse
– Damage caused by anything other than defects in material and workmanship
– Dropping or other excessive impact
Normal maintenance and service that can be carried out by the operator:
• Changing of the backing pad
• Changing of the exhaust fitting
• Changing of the shroud
NOTE! All other service operations must be carried out by an authorized Mirka service center .
Work stations
The tool is intended to be operated as a hand-held tool . It is always recommended that the tool should be used when
standing on a solid floor . It can be in any position but before any such use, the operator must be in a secure position
having a firm grip and footing and be aware that the sander can develop a torque reaction . See the section "How to get
started" .
How to get started
1 . Make sure tool is turned off and unplugged . Select a suitable abrasive disc and attach it to the tool, ensuring that
the disc is centered on the backing pad .
2 . Connect the cord from the tool to the DC power transformer . Cord will click when locked in place . Refer to Figure
1–2 . Ensure power switch is in the off position .
3 . Connect the AC power cord to the DC transformer socket, and plug into grounded wall outlet .
4 . Switch on the DC transformer with the On/Off switch Figure 2 . The power supply LED will cycle from red to green,
indicating that power is available to the tool .
5 . Keep hands free of throttle lever . Switch on the sander by pressing the Power Button shown in Figure 1 . The sander
LED will turn green, indicating the tool is ready for use .
6 . The sander can now be started by pressing the throttle lever .
7 . The maximum speed can be adjusted between 4,000 and 10,000 rpm by pressing the rpm+ or rpm– buttons shown
in Figure 1 . Each press adds or removes 1,000 rpm until it reaches the limits .
8 . The throttle lever can operate in two modes . To change lever modes, press and hold the + and – buttons for several
seconds . In mode 1, it acts as an on/off switch . When the lever is depressed, the tool will operate at the maximum
adjusted speed . In mode 2, the throttle lever acts as a variable speed switch . As the lever is depressed, the tool will
operate between 4,000 rpm and the maximum adjusted speed .
9 . The tool speed can also be adjusted when running . Press the + button to increase speed in 1,000 rpm increments up
to 10,000 rpm .
10 . For vacuum operation, a 1–1/4" vacuum hose can be threaded into the tool fitting .
11 . When sanding always place the tool on the work surface then start the tool . Always remove the tool from the work
surface before stopping . This will prevent gouging of the work surface due to excess speed of the abrasive .
12 . When done sanding, or before changing discs, turn off the tool by pressing the power button on the handle . Switch
off the DC transformer, and remove the AC power cord . The power supply LED will slowly fade . Finally, unplug the
power cord between the tool and the DC transformer . Always turn off tool before changing abrasive discs.
92
Mirka® CEROS • 150 mm (6") • 125 mm (5") • 77 mm (3")