Work Stations; How To Get Started; Disposal Information; En Operating Instructions - MIRKA CEROS Instructions D'utilisation

en

Work stations

The tool is intended to be operated as a hand-held tool . It is always recommended that the tool should be used when
standing on a solid floor . It can be in any position but before any such use, the operator must be in a secure position
having a firm grip and footing and be aware that the sander can develop a torque reaction . See the section "Operating
instructions" .

How to get started

Connect the power cord to the power supply unit and connect the other end to the mains supply . Connect the DC plug
of the sander to the power supply DC socket . Please look at Figure 1–2 .
In order to get full power from this tool it is recommended that it is used together with the Mirka vacuum
cleaner 412/415 or 912/915 and Mirka Net Sanding products. This makes the sanding work very convenient and
dust-free . The power supply can then be mounted on the vacuum cleaner with the brackets kit MIN6519111 .
In this application the power cord from the power supply is connected to the mains supply at the front of the
vacuum cleaner . This makes it possible to auto-start the vacuum cleaner when the lever on the sander is pressed .
Operating instructions
1 . Make sure the sander is switched off . Select a suitable abrasive and secure it to the backing pad . Take care to centre
the abrasive on it . For optimal use of the machine we recommend a Mirka Net Sanding product .
2 . Switch on the power supply unit with the On/Off switch Figure 2 . The power supply LED is now green .
3 . Switch on the sander by pressing the On/Off key Figure 1 . The sander LED is now green .
4 . The sander can now be started by pressing the lever .
5 . The speed can be adjusted between 4 000 and max rpm by adjusting the position of the lever .
6 . The max rpm can be adjusted by pressing RPM+ or RPM– buttons, Figure 1 . Each press increases or reduces the
speed by 1 000 rpm until it reaches the limits . The rpm can be adjusted in the range 4 000 to 10 000 rpm .
7 . The tool has two modes of controlling the speed . In the default mode the speed can be adjusted linearly by
adjusting the position of the lever . In the other mode the speed is always fixed at the adjusted max rpm when the
tool is running . When the RPM+ and RPM– buttons are pressed simultaneously the tool toggles between the two
controlling modes .
8 . When sanding always place the tool on the work surface then start the tool . Always remove the tool from the work
surface before stopping . This will prevent gouging of the work surface due to excess speed of the abrasive .
9 . When sanding is finished turn off the sander by pressing the On/Off key . The sander LED is now turned off .
NOTE! If the sander is used with an Interface it is recommended that the speed is set to a maximum of 7 000 rpm .

Disposal information

DANGER!
Disposal guidelines for old appliances . Render redundant power tools unusable by removing the
power cord . Only for EU countries . Do not dispose of electric tools along with household waste .
According to European Directives 2002/95/EC, 2012/19/EU + 2003/108/EC on waste electrical and
electronic equipment and its implementation under national law, electric tools that have reached the
end of their life must be collected separately and taken to an environmentally compatible recycling
facility .
26
Mirka® CEROS • 150 mm (6") • 125 mm (5") • 77 mm (3")