Important - MIRKA CEROS Instructions D'utilisation

Declaration of conformity
KWH Mirka Ltd, 66850 Jeppo, Finland
declare on our sole responsibility that the products Mirka® CEROS 150 mm (6 in .), 125 mm (5 in .) and 77 mm
(3 in .) 10 000 rpm Electrical Random Orbital Sander – (see "Technical data" table for particular model) to which this
declaration relates are in conformity with the following standard(s) or other normative document(s): EN 60745,
EN 55014, EN 61000 in accordance with the regulations 2006/42/EC, 2014/30/EU, 2011/65/EU .
Jeppo 19.05.2014
Place and date of issue
Operating instructions, contents:
Exploded view, Parts list, Spare parts, Sander
parts, Power supply unit parts, Declaration
of conformity, Important, Required personal
safety equipment, Additional safety warnings,
Proper use of tool, Work stations, How to
get started, Operating instructions, Disposal
information, Technical data, Noise and
vibration information, Troubleshooting guide .
We reserve the right to make changes to this manual without prior notice .

Important

Read these safety and operating instructions carefully before installing, operating or maintaining this tool . Keep these
instructions in a safe, accessible location .
Required personal safety equipment
Read
operator's manual safety glasses
Additional safety warnings
a) Always ensure that the material to be sanded is firmly fixed to prevent its movement.
b) Dust can be highly combustible. The vacuum dust collection bag should be cleaned or replaced daily.
Cleaning or replacing of the bag also assures optimum performance.
c) Keep hands clear of the spinning pad during use.
d) Do not allow the tool to free speed without taking precautions to protect any persons or objects from
the loss of the abrasive or pad.
Proper use of tool
This sander is designed for sanding all types of materials i .e . metals, wood, stone, plastics, etc . using abrasive designed
for this purpose . Do not use this sander for any other purpose than that specified without consulting the manufacturer
or the manufacturer's authorized supplier . Do not press on the shroud when sanding . Pressing on the shroud will
reduce its lifespan . Do not use backing pads that have a working speed less than 10 000 rpm free speed . The cooling
air vents on the housing must always be kept clean and free of blockages to ensure air circulation . Any maintenance or
repair work requiring the motor housing to be opened may only be carried out by an authorized service centre .
Company
Manufacturer / Supplier
KWH Mirka Ltd
66850 Jeppo, Finland
Tel . +358 20 760 2111
Fax +358 20 760 2290
www .mirka .com
Wear
ear protection
Stefan Sjöberg, CEO
Input voltage
90–240 VAC
Wear
safety gloves
Mirka® CEROS • 150 mm (6") • 125 mm (5") • 77 mm (3")
Wear
face mask
en
Wear
25