Phono Operation - SOUNDMASTER PL905 Mode D'emploi

- This is recommended to take out the cassette tape from the system every times after listening and don't leave the
cassette tape inside the system when not under playback mode.

Phono Operation

Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before operating and
-
re-secured again afterwards.
1. Rotate the function button to select phono mode. The LCD display will show " PHON"
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Set the cueing lever to the up position.
5. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate and position the tone
arm over the desired position of the record.
6. Pull down the cueing lever. The tone arm will come slowly on the recorder and start playback.
7. At the end of record, the tone arm will return to the rest position automatically.
8. To stop manually, lift the tone arm from the record and return it to the rest.

Play suspension
Set the cueing lever to the up position will life up the tone arm and then stop playback temporarily.
Remark :
- Due to the auto return system was mechanical design and reset point will affected after transportation.
Thus, the tone arm will return to the rest automatically when first time place the tone arm to the platter
and it was not the malfunction.
- Due to the length of the record is various, if you find the tone arm cannot return automatically after
playback the record. Please press the eject button and return the tone arm back to the rest position
- Users should not change to a magnetic cartridge system, otherwise unit cannot be connected anymore
to other music-centre
Adjustments
Pitch adjust control
The pitch adjust control is made adjust the turntable speed lightly.
-
Tone arm stopping position alignment
The position of the tone arm complete playback and return to the rest station can be adjusted at the alignment screw (26)
-
as follow:-
Before starting the alignment, please take out the hole covering rubber:-
-
A) If the system cannot complete the playback of record and return earlier
1) Use a cross head screw driver and turning the alignment screw (26) inside the hole clockwise, the stopping and eject
position of the tone arm will move more inward to the center of the record before playback completion.
23