SOUNDMASTER PL905 Mode D'emploi page 18

Location of controls
1) Remote sensor
2) Standby LED indicator
3) LCD display
4) Power/Function button
5) Left Speaker
6) CD tray open button
7) CD tray
8)
CD tray eject hole
9) Volume +/- button
10) Finalize button
11) CD stop button
12) Record button
13) CD play/pause
14) Turntable Platter
15) CD Skip down / CD Skip up
16) USB/Tuner skip down
17) USB play/stop button
18) Earphone jack
19) Aux in jack
20) Right Speaker
21) USB socket
22) Cassette forward/eject knob
23) Cassette slot
24) Dust cover
25) Spindle adaptor
26) Alignment screw with rubber cover
27) Counter weight
28) Pitch adjust
29) Turntable speed selector
30) Cueing lever
31) Tone-arm lock
32) Line out jack
33) FM antenna
34) AC line cord
Remark : control location from 35-47 on remote control
mentioned at last page of this I/M
Caution:
Usage of controls or adjustments or performance of procedures other than those specified herein may result in hazardous
radiation exposure.
This unit should not be adjusted or repaired by anyone except qualified service personnel.
Precautions for use
Installation

Unpack all parts and remove protective material.

Do not connect the unit to the mains before checking the mains voltage and before all other connections have been
made.

Do not cover any vents and make sure that there is a space of several centimeters around the unit for ventilation.
Installation of counter weight
1. Slide in the counter weight completely into the rear of the tone arm until it reach the end, turn it clockwise until it click with
pit inside.
2. Twist the counter weight clockwise & backward until it reach the white line as figure 2
3. Twist the counter marking until it reach " 1 " position
4. Twist the counter weight anti-clockwise & inward until it reach the appropriate working pressure.
button
button
/ Skip up button
17