Clear Records; Other Operations And Settings; Activate Backlight; Beep Tone On / Off - Oregon Scientific SE336 Manuel De L'utilisateur

To return to the screen which shows date and time of
exercise session: touch MODE/-.

CLEAR RECORDS

This watch can contain data for up to 99 exercise sessions.
Individual memory cannot be selected and deleted. The
watch only allows for all data to be deleted.
To delete memory:
1. Touch MODE/- repeatedly to select "MEM".
2. Touch +/ST/SP repeatedly until "DELETE" will be
displayed.
3. Touch MODE/- to confirm.
DONE indicates the record has been cleared.
MODE/-
When starting an exercise and memory is full, "FULL" will be
displayed, followed by "DELETE".
• Touch MODE/- to delete all records
OR
Touch Enter
• to ignore and start an exercise without
recording data for it.
+/ST/SP
MODE/-

OTHER OPERATiONS AND SETTiNgS

ACTiVATE BACKLigHT

Touch EL. (Touch EL again to extend backlight for another
5 seconds).
NOTE
The backlight function will not operate if " " is
displayed.

BEEP TONE ON / OFF

When time is displayed, touch +/ST/SP to activate /
deactivate beep tone.
indicates beep tone is deactivated.

REPLACE BATTERY

If the battery power of your watch or chest belt is low, the
watch will display:
Watch
Chest belt
To replace watch battery:
1. Use a coin to open the battery compartment lid by
turning it anticlockwise.
2. Remove the old battery and insert a new CR2025, 3V
lithium battery.
12
"HR BELT LOW BATT"