The battery can be charged at temperatures between 0°C
and 45°C.
SEAT TUBE BATTERY
Battery in the docking station
If a charging fault occurs, the LED (where present)
in the charger lashes red. In this case, the charg-
ing current is too high. Consult your specialist
cycle shop.
7 Control panel and display
The Pedelec Impulse 2.0 can be controlled via two ele-
ments. The control panel can be found on the handlebar
grip; the display is located in the middle of the handlebar.
7.1
Control panel
1
2
3
4
1
button, on and of button
2
button, increase value/scroll up
3
button, decrease value/scroll down
4
button
Press the
button to switch the system on and of.
Buttons 2 to 4 have diferent unctions depending on the
item of the settings menu in which you are located.
7.1.1 Switching on/of
Press the
button on the control panel to switch the Im-
pulse system on. Ater a few seconds, the welcome screen
appears, followed by the start menu. From there you can
carry out urther settings
settings".
Ater switching on, the system is always in the
display mode in which you switched it of.
To switch your Pedelec of, press the
trol panel in the start menu.
7.1.2 Push assist
The pushing assistance moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to turn the
pedals, e.g. if you are manoeuvring in a tight space or are
pushing your Pedelec out of a basement garage.
To activate the pushing assistance, press the
three seconds.
The pushing assistance is not suitable for use as
starting assistance.
7.1.3
/ buttons
• You can speciy the power-assist level via the
buttons.
• Each time you press one of these two buttons the
power assist changes by one level. If you press the
button, the level of assistance increases by one
level each time you press it. If you press the
button, the assistance becomes weaker each time
you press it.
Original User Manual | Pedelec Impulse 2.0
Chapter 7.4 "Programming and
button on the con-
button for
/
17