Quick Start; Battery - Kalkhoff inpulse 2.0 Mode D'emploi

4 Quick start

Charge the battery completely before riding for the irst
time. Charge temperature: 0°C to 45°C.
SEAT TUBE BATTERY
Charging the battery
1. Remove the cover rom the charging socket.
2. Connect the plug of the charger to the battery.
DOWN TUBE BATTERY
Charging the battery
3. Insert the mains plug for the charger into the socket.
You must charge the battery completely before
using it for the irst time. As required by transport
law, the battery leaves the factory with an ap-
proximately 30% charge.
You can also remove the battery rom your Pedelec
and charge it elsewhere. For more information,
Chapter 5 "Battery". Please note, the
refer to
battery is heavy. Hold on tight to it!
4. Once all of the battery LEDs have gone out, the battery
is ully charged. Pull the plug of the charger out of the
charging socket and take the mains plug of the charger
out of the socket.
5. a) Down tube battery: If you removed the battery for
charging, replace it in the holder rom the ront/above.
At the same time, the key must be in the lock and must
be turned anticlockwise. Press the battery down into
10 Original User Manual | Pedelec Impulse 2.0
SEAT TUBE BATTERY
the holder until the locking mechanism engages.
b) Seat tube battery: If you removed the battery for
charging, reinsert the battery into the holder on the
Pedelec rom the let-hand side. Tilt the battery out-
wards at an angle of roughly 45° as you do so. Move
the battery into the upright position until the locking
mechanism engages.
DOWN TUBE BATTERY
Installing the battery
6. Now turn the key clockwise and remove it. The battery
is now locked in place.
DOWN TUBE BATTERY
Locking the battery
7. Make sure that the battery is securely positioned and
that the key is no longer in the lock.
8. Press the button on the control panel to switch on
the drive system.
9. a) Pedelec without backpedal unction: Ater the wel-
come screen, the display shows the power-assist mode
that was last set. Press the
level of assistance: ECO (low), SPORT (medium),
POWER (high) or no assistance. Pressing once changes
the level of assistance by one level. This works both
ways, depending on which of the buttons you press.
b) Pedelec with backpedal unction: Ater the welcome
screen, the display shows "Please move the pedals"
or "PEDAL". This instruction will disappear as soon as
you start riding. Press the
level of assistance: ECO (low), SPORT (medium),
SEAT TUBE BATTERY
SEAT TUBE BATTERY
/ buttons to select the
/ buttons to select the