b) Optical and acoustic indication
Status
1. In Programming mode
2. switch operations
3. correct Code-entree
4. Wrong Code-entry
5. DAP-Jumper is while of
the mains voltage on "ON"
6. standby mode
7. Output is activated
The entry and activation sounds can be switched on and off (see programming mode
81 and 83).
c) Programming explanation
0000
Master code (on delivery)
You can perform all programming operations after entering the master
code (0000) and then pressing the key .
All further programming steps can only be done after entering the master code and
confirming it with the
after the other.
Press the
key to leave the programming mode.
52
Beeper
off
1 x beeping
2 x beeping
5 x beeping
permanent
at the Base station
off
1 s Beep sound
key. Multiple programming steps can be carried out one
"MAIN" LED
illuminates
flashing 1 x
flashing 2 x
flashing 5 x
beeping
all two seconds a flashing
all two seconds a flashing