Mounting - Renkforce DK-9827 Notice D'emploi

b) Mounting
Choose a suitable location for your code lock that allows the system to be easily ope-
rated.
Use a suitable screwdriver to remove screw (3) of the control unit.
Remove the cover from the rear of the control unit.
Use the holes in the cover as a drilling template and mark the position of the mounting
holes.
Make sure that there are no electric wires, water pipes, or similar systems
behind where you will be drilling.
Remove the cover and drill the mounting holes.
Lay all cables required, depending on the intended use.
Screw the cover into position using the screws provided. If necessary, use screw fit-
ters.
To get to the connection strips 1 and 2, loosen the four inward crews at the code lock
and take off the water jet cover.
42