Renkforce DK-9827 Notice D'emploi page 55

Programming the "Output 2" relay
50 1 to 999
51
52
Programming the NPN open collector output 3
60 1 to 999
61
62
# After entering User code 2 and pressing the # key, re-
lay 2 switches on for the programmed time (1 to 999
seconds).
# After entering User code 2 and pressing the # key, relay
2 toggles (from closed to open or vice-versa).
# After entering User code 2 and pressing the # key, relay
2 toggles (either from closed to open or from open to
closed).
This programming also allows the use of a short code
for switching (the first two digits of code 2).
# After entering User code 3 and pressing the # key, NPN
output 3 switches to ground (-) on for the programmed
time (1 to 999 seconds).
# After entering User code 3 and pressing the # key, NPN
output 3 toggles (from closed to open or vice-versa).
# After entering User code 3 and pressing the # key, NPN
output 3 toggles (from closed to open or vice-versa).
This programming also allows the use of a short code
for switching (the first two digits of code 3).
55