TOHATSU EverRun MX 40D2 Manuel De L'utilisateur page 15

Note
Minimum recommended battery: 12V, 70AH
(800 Marine Cranking Amps (MCA) or 650
Cold Cranking Amps (CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
WARNING
Battery generates explosive hydrogen gas.
Be sure to:
 Charge the battery in a well-ventilated
place.
 Place the battery away from any source
of fire, sparks and open flames such as
burners or welding equipment.
 Do not smoke when handling the bat-
tery.
 Do not smoke near the battery when the
battery is charging.
CAUTION
 Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
 The starter motor may fail to operate if
the leads are incorrectly connected.
 Be sure to correctly connect the (+) and
(—) leads. If not, the charging system
will be damaged.
 Do not disconnect the battery leads
from battery while the engine is operat-
ing, the electrical parts could be dam-
aged.
 Always use a fully charged battery.
CAUTION
Do not use a battery that is not recom-
mended. Use of a battery not recom-
mended can lead to poor performance of,
and/or damage to, the electrical system.
2 Connect the positive lead (+) to the pos-
itive terminal (+) of the battery, and then
connect the negative lead (—). When
disconnecting the
remove the negative lead (—) first. After
connecting the positive terminal (+),
securely place a cap on it to prevent
short circuits.
1. Battery cord (red)
2. Battery cord (black)
INSTALLATION
battery always
2
1
15
3