Connecting The Ir Module; Frequently Asked Questions (Faqs) - Marmitek Invisible Control 6 XTRA Guide Utilisateur

5.4

Connecting the IR Module

1 Connect the installed IR Extender cables with blaster LEDs)
to the 'IR OUT' connection on the IR Module.
2 Connect the installed IR Receiver cable to the 'IR IN'
connection on the IR Module:
3 Connect the USB Power adapter to the 'POWER' connection
on the IR Module and plug this into an electrical socket.
4 If the Invisible Control 6 XTRA™ is correctly connected, the
'IR data' light will blink on the IR Module if you press a button
on the (infrared) remote control while pointing towards the IR
receiver.
5 Close the doors of your cabinet to ensure that the A/V
equipment cannot receive an infrared command directly from
the remote control as this can lead to operational problems.
6 You can now operate the A/V equipment via the Invisible
Control 6 XTRA™ through closed cupboard doors!
6

Frequently asked questions (FAQs)

The A/V equipment does not respond to signals from my
remote control.
Take the following instructions into account:
The IR receiver has a receiving sensitivity of about 10 metres

with an acceptance angle of 60 degrees. Range is also
dependent on the remote control used.
If the 'IR data' light on the IR Module is continuously

illuminated, the IR receiver is probably being disrupted by
another infrared signal. Try to locate the IR receiver so that it
encounters as little disruption as possible from, for example,
Invisible Control 6 XTRA 9