1. Introduction
The Silverline 8 is designed to control up to 8 devices:
TV, VCR, CBL (decoder, set top box), DVD, CD, ASAT
(analogue satellite receiver), DSAT (digital satellite
receiver) or any other device under AUX mode key. The
Silverline 8 contains a library of codes that are pre-
programmed into the remote control. This library covers
nearly all the audio video products on the market today.
The codes have to be programmed once before use.
This can be done in different ways:
a. Manual entry of one of the codes displayed under
the related brand and type of equipment in the
attached code book (see 4.1)
b. Automatic code search for some well-known
brands (4.2)
c.
Automatic code search for all brands (4.3)
d. Manual search through all codes (4.4)
2. Insert the batteries (always use NEW
AAA alkaline batteries).
1. Open the cover on the back of the Silverline 8
Remote.
2. Insert 2 AAA alkaline batteries, verify that they are
placed correctly with the + on the battery in the
same position as marked inside the battery
compartment.
3. Close the battery compartment carefully.
3. Function of the remote's buttons
[1]
(On/Off)
Allows you to switch off the last selected appliance.
Some appliances can also be switched on with this
button.
[2] RED LED indicator
The indicator light flashes when the remote is operating or
lights continuously while you are programming the remote.
[3] TV, VCR, CBL, DVD, CD, ASAT, DSAT, AUX
These keys allow you to select the appliance you wish
to control. For CD a limited amount of functions are
available.
[4]
MUTE
Allows you to turn on/off the sound. You can control the
"Mute" function of your TV even when you are in VCR,
DVD or SAT mode. No need to select the TV mode.
[5] PROG +/-
Select the next or the previous channel of your TV or
SAT.
In DVD mode: next or previous chapter.
[6] VOLUME +/-
Allows you to control the volume. You can control the
volume of your TV even when you are in VCR, DVD or
SAT mode. No need to select the TV mode.
4
SILVERLINE 8