Changing The Home Automation House Code; Programming The Home Automation Ir/Rf Mode - Marmitek EASYTOUCH 35 Mode D'emploi

easytouch35_manual ok
To switch on/ off an appliance plugged into an home automation module: Press
the key (2), then press the unit code of the home automation module on the
Touchscreen display and then press CHAN+ / - (8).
To dim/bright a light plugged into a home automation module: press its unit code
on the Touchscreen display and then press VOL+ / - (4).
To turn ON all the home automation Lamp modules: Press the Power key (3).
To turn Off all the home automation modules (Lamp and appliance): press the
Mute key (7).

14.1. Changing the home automation House Code

The preset house code is A and in the majority of cases it is not necessary to change this
setting except if there is interference from neighbouring Marmitek X10 systems. In that case:
1. Press the Marmitek X-10 Home Automation
2. Press and hold SETUP until the LED lights continuously.
3. Release the SETUP button.
4. Press the SETUP button again.
5. Use the digit keys on the Touchscreen display to enter the number equivalent to the
chosen home code (1=A, 2=B, ... 16=P).
6. Press ENTER followed by EXIT to confirm your command.
Note: The code you have chosen has to be the same as the one selected on the
Transceiver module TM13 or the security console, with which you use your remote.

14.2. Programming the Home Automation IR/RF mode

Your ET35 remote control can control your electric appliances using infrared signals (via an
infrared mini-controller IR7243) or RF signals (via a transceiver module TM13). The
is set to RF mode by factory setting.
To program the
EASYTOUCH 35
6/17/03 10:30 AM
key to send an Infrared signal, proceed as follow
1. Activate your ET35 remote by touching the screen
2. Press and hold the Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and display
shows the Main Setup Screen.
3. Release Setup key.
4. Press and release the Touchscreen "CODE" Key.
Page 21
key
key
21