Adding Your Pet To The Feeder - SURE petcare SUREFEED Microchip Pet Feeder Connect Guide D'utilisation

Adding your pet to the Feeder

When adding your pet's microchip ID into the Microchip Pet Feeder Connect, make sure
all other pets and any unrequired collar tags are kept out of the way.
1
Press the 'Add a pet' (
found at the rear of the Feeder.
3
Put some food/treats into the
bowl and place the Feeder where
you would normally feed your pet.
5
When your pet moves away, the lid will
close and the green LED will turn off. Their
microchip ID is now permanently stored.
To program a pet's microchip ID, sensors located in the hoop of the Feeder must detect the pet's
presence. Therefore it's important to ensure your pet places their head through the hoop to eat.
To program a Sure Petcare RFID Collar Tag, simply follow the steps above but hold the collar tag
inside the hoop. Make sure you are not wearing any metal jewellery when programming a collar tag.
If you already have a pet in your Sure Petcare household, it is possible to assign them to the
Feeder. Go to the Household section of the app. If you add the wrong pet by mistake you can
always correct it here.
15
2
) button
4
Whilst your pet eats, the Feeder scans their
microchip ID. Once the ID has been added,
the LED will stop flashing (but remain on).
If you need to, you can cancel the 'Add a
pet' mode at any time with a second press
T he lid will open and the rear LED
will flash green once every second.
of the 'Add a pet' ( ) button.