Learning Your Pet Into The Feeder - SURE petcare SureFeed Microchip pet feeder Guide D'utilisation

Learning your pet into the feeder

When learning your pet into the feeder, make sure all other pets are kept away. If the
wrong pet is accidentally learnt you can perform a factory reset, as detailed in the
troubleshooting - see page 18. You can also use the Sure Petcare RFID Collar Tag if
your pet does not have a microchip and wears a collar.
1
Press the Add Pet ( ) button found on the
rear of the feeder.
3
Put some food/treats into the bowl
and place the feeder where you would
normally feed your pet.
In order to learn a pet's microchip number, sensors located in the hoop at the front of
the feeder must detect a pet's presence. Therefore it is important to ensure that your
pet places their head through the hoop to eat.
If you want to use the feeder for more than one pet, you can do this by repeating the
process. You are able to store up to 32 pets in each feeder.
2
The lid will open and the light
will flash green once every second. The
feeder will stay in this mode until a pet is
learnt or if you cancel with a second press
of the Add Pet ( ) button.
4
When your pet eats from the bowl and has
been learnt, the light will stop flashing and
remain on. When your pet moves away from
the feeder the lid will close and the green
light will turn off. Their microchip number is
now stored permanently in memory, even
when the batteries are removed.
EN
10