Set Up Your Hub - SURE petcare SUREFEED Microchip Pet Feeder Connect Guide D'utilisation

Set up your Hub

Once you have successfully downloaded the Sure Petcare app, you will need to plug in
your Hub and set it up. Once your Hub is set up you will be asked to connect it to both the
Feeder and the app. Please follow the steps below:
1
2
3
4
Your Hub may receive a software update. If you see solid red lights during
setup, don't panic, your Hub is updating its software. Once complete the Hub
will reboot and you'll see the light sequence detailed in step 3.
Plug one end of the Ethernet cable into the base
of your Hub and the other end into a spare Ethernet
port on your router.
Assemble the power supply and plug it into your
power outlet. Plug the other end of the cable into
the base of your Hub.
Your Hub's 'ears' will start alternating red
and then green. When both ears remain solid
green your Hub is ready. If the ears fail to do this
sequence please see page 10 for more information.
In order to complete the setup of your Microchip
Pet Feeder Connect system you will need to follow
the remaining steps on the Sure Petcare app.
EN
8