Electromagnetic Compatibility En 60601-1-2; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Mectron COMPACT PIEZO LED Mode D'emploi Et D'entretien

COMPACT PIEZO LED
Protections of the APC circuit:
Operating conditions:
EN
Transport and storage conditions:
09.1 Û ELECTROMAGNETIC COMPATIBILITY EN 60601-1-2
WARNING: Interference with other
equipment. Though compliant with the
standard IEC 60601-1-2, the compact piezo
LED may nonetheless interfere with other
devices nearby.
The compact piezo LED must not be used
near to or stacked on other devices. If
adjacent or stacked use is necessary, the
compact piezo LED and the other devices
must be observed and checked to verify
normal operation in the configuration in
which they will be used.

Guidance and manufacturer's declaration - Electromagnetic emissions

The compact piezo LED is intended for use in the electromagnetic environment specified
below. The customer or user of the compact piezo LED should ensure that it is used in such an
environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
22
No handpiece detected
Cord interruption
Insert not tightened correctly or broken
from +10°C to +40°C
Relative humidity from 30% to 75%
Pressure of air P: 800hPa/1060hPa
from -10°C to +70°C
Relative humidity from 10% to 90%
Pressure of air P: 500hPa/1060hPa
communication appliances may affect the
correct functioning of the device.
equipment. The use of an electrical scalpel
or other electro-surgical unit/s near the
compact piezo LED may interfere with its
correct functioning.
EMC precautions and must be installed
and activated in accordance with the EMC
information given in this paragraph.
Compliance Electromagnetic environment – Guidance
Group 1
The compact piezo LED only uses RF energy for
internal function. Therefore, its FR emissions
are very low and are not likely to cause any
interference with nearby electronic
equipment.
Class B The compact piezo LED is suitable for use
in all establishments, including domestic
establishments and those directly connected to
Class A
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Complies
WARNING: Portable and mobile radio
WARNING: Interference from other
WARNING: The device requires specific