Installation Of The Cvd Drive Shafts (Optional) - Reely ROAD P-190 Notice D'emploi

i) Installation of the CVD drive shafts (optional)
Unscrew the front wheels, loosen the screw connections of the steering
knuckle pin at the axle leg support and pull the axle legs out of the axle
leg support.
Remove the hexagon driver from the spindle and take the spindle from
the axle leg.
Guide the longer end of the cardan joint through the axle leg support and
put the shaft into the driver on the front axle differential.
Guide the other end of the shaft (the spindle) the axle leg and screw it
back onto the axle leg support. Replace the hexagon driver and screw
the wheel tight.
59