Installing The Servos And The Receiver Of The Arr Model - Reely ROAD P-190 Notice D'emploi

m) Installing the servos and the receiver of the ARR model
Installation of steering servo
• Place the servo shaft via the remote control in the neutral position.
• Unscrew the RC installation base and the support of the transverse
stabilizers (eight screws)
• Insert the steering servo with the servo shaft pointing to the front into
the recess of the RC installation base from the bottom.
• Separate two servo attachments from the accessories (a) and screw in
the servo through the RC plate in the attachments.
Connecting the steering servo
• Point the wheels forward.
• Replace the RC installation plate and screw it onto the distancer bolts
and the transmission case.
• Fix the lateral stabilisers with the retainer plates on the chassis through
the RC installation plate.
• Plug the servo arm on the servo shaft of the steering servo so that the
reversing lever left runs parallel on the outside to the longitudinal axis
of the vehicle.
• Make sure that the servo shaft remains in neutral position and that the
wheels are pointing straight ahead.
• Also make sue that the servo lever moves tension-free and that the full
steering deflection can be achieved.
• Screw the servo arm tight in this position on the servo shaft, from the
bottom through the opening in the chassis.
Our tip:
We recommend also installing the throttle/brake servo at this time , before you permanently install the RC installation base!
Installation of throttle/brake servo
• The throttle/brake servo is attached to the rear recess of the RC
installation base.
• Slide the servo from below into the recess, servo shaft forward and
screw it together with the two remaining servo attachments (a).
46