Starting The Engine - Reely ROAD P-190 Notice D'emploi

o) Starting the engine
General information about combustion engines
When putting the new engine into operation, you have to observe a certain run-in time. During the break-in time, engine parts tune to one another,
whereby maximal capacity is reached and premature wear is prevented.
Thus, the run-in procedure must be carried out with the highest accuracy!
Preparations
• The carburettor is already roughly preadjusted.
• Before running the engine blow compressed air into the latter.
This way you make sure that the combustion chamber is free of dirt which could get into the engine via the spark plug seat.
• Insert a glow plug with the thermal value medium to extra cold (depending on the fuel).
• Oil the air filter slightly in order to filter out dust particles
• Insert the glow plug.
• Open the tank lid and fill in the fuel.
Start the motor
The wheels must be freely suspended in the air! Place the model e.g. on a suitable car stand.
• Pull the cable starter several times (slowly!) to suck fuel into the carburettor.
• Do this until there are no more visible air bubbles in the fuel hose and the fuel just about reaches the carburettor.
Caution!
Don't pull out the cable starter all the way but only to a maximum of 3/4 of its length. Determine the length of the pull starter by pulling it out slowly
without ignition!
Never pull out the cable starter by force!
• Attach a glow plug starter with completely charged starter battery on the glow plug (see ill. on the right). Ensure a tight fit!
• Now pull the cable pull starter through until the motor starts up. Hold the model firmly with one hand.
However, never reach into the drive because this could cause the engagement of the sliding clutch. Risk of injury!
• Once the motor is running, let go of the cable starter and remove the glow plug starter.
Only leave the glow plug starter connected to the engine briefly. Otherwise, the glow plug may burn out prematurely.
• If the pull starter can only be actuated with a lot of force after several unsuccessful start attempts, too much fuel got into the combustion chamber and the
crankcase. The engine has been flooded.
Refrain from further start trials and remove the excess fuel in order to prevent damaging the cable pull starter and the engine!
Proceed as follows to remove the fuel:
• Carefully turn in the main nozzle needle clockwise, as far as it will go.
• Unscrew the glow plug and check its glow function
• Place a piece of cloth on the engine and pull the cable pull starter 5-6 times (3/4 of the length!): Fuel is pumped out and evaporates.
• Now insert the glow plug again.
• Unscrew the main nozzle needle with 3 rotations anticlockwise.
• Repeat the start process.
If the engine does not start after at most 10 attempts, proceed as described above or try to locate the error in the troubleshooting table!
50