Additional Functions; Setting Day And Night Temperatures - MCZ FORMA GAS 55/75/95/115 Guide De L'utilisateur

8.1

Additional functions

The display screen on the remote control unit always shows one of the functions below:
By pressing the the SET-key (fig. 1.6) briefly, the various functions can be shown consecutively.
MAN 
manual operation.
MAN
If the indication MAN is shown in the display screen, the hearth can adjusted to a higher or lower flame position
by pressing the -key or the -key (fig. 1.9 of 2.0), see paragraphs. 6.2 en 6.3.
NOTE: By pressing the
thermostat and/or timer programmes are switched off.
Day temperature
TEMP
If the indication for day temperature is shown in the display screen, the thermostat will make sure the
environmental temperature agrees with the settings for day temperature.
Night temperature
TEMP
If the indication for night temperature is shown in the display screen, the thermostat will make sure the
environmental temperature agrees with the settings for night temperature.
Timer function
TIMER
In this "clock thermostat" function the duration of the periods for day and night temperatures is set within 24
hours.

8.2 Setting day and night temperatures

 Move the SET-key (fig. 1.6) step by step to TEMP.
 Now keep the SET-key (fig. 1.6) pushed in for a long time until the temperature indication in the display
screen starts to blink.
 In accordance with your wishes, increase the Day temperature with the
the -key (fig. 2.0).
 Press the SET–key (fig. 1.6) again, now TEMP appears in the display screen.
 Now keep the SET-key (fig. 1.6) pushed in for a long time until the temperature indication in the display
screen starts to blink.
 In accordance with your wishes, increase the Night temperature with the
with the -key (fig. 2.0).
Note! The lowest temperature that can be set is 5 ºC. If you don't want the hearth to switch on at night,
keep pressing the
 Save the settings by pressing the OFF- key (fig. 1.8) or wait for ten seconds.
FORMA GAS 55/75/95/115
USER MANUAL

TEMP TEMP
- key or the -key (fig. 1.9 of 2.0), the manual operation is switched on and the active
-key (fig. 2.0) until the sign - - appears in the display screen.

TIMER
-key (fig. 1.9) or lower it with
-key (fig. 1.9) or lower it
Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
6
page