First Time The Hearth Is Operated; Remote Control Unit - General Remarks; Placing The Batteries In The Remote Control Unit; Placing The Batteries In The Receiver - MCZ FORMA GAS 55/75/95/115 Guide De L'utilisateur

4. First time the Hearth is Operated

Before ignition, remove all stickers, protective wrappings and, if present, rubber protective padding from the
glass.
Make sure the room is properly ventilated the first time the hearth is switched on. Burn the hearth at the highest
position for some hours so that the lacquer coating will have an opportunity to set and possible vapours released
can be safely removed by ventilation. Keep children and pets outside the room during this process!
5. Remote control unit – general remarks
The appliance has been supplied with a remote control set; this consists of the remote control unit (fig. 1.1) and
the receiver(fig. 1.2). The receiver as well as the gas control block (fig. 1.3.1) are located behind: a panel in the
chimney breast, a drawer underneath the hearth or behind a frame.
 The remote control has been provided with 3 keys (fig.1.1). All functions of the hearth can be operated
with these keys.
 If the transmission is successful, the receiver will emit a sound signal.
 With the help of a toggle switch F (fig. 1.2) the hearth can always be switched off.
 Put the toggle switch F (fig. 1.2) in position – O, if the hearth is not in use for a longer period.
 With the help of the switch knob B (fig. 1.3.1) the flame height can be regulated without operating the
remote control unit.
 The dial A (fig. 1.3.1) should always be on the ON position. The MAN position is only intended for
service purposes.
When using the thermostat / timer function, the wall bracket supplied (fig. 2.4/2.5/2.6) should always be placed
within 4 metres of the hearth.

5.1 Placing the batteries in the remote control unit

 Remove the lid at the back of the remote control unit. (fig. 2.1)
 Place a 9Volt MN1604/6LR61 Alkaline long life battery.
 Close the lid.

5.2 Placing the batteries in the receiver

 Take the receiver (fig. 1.2) out of the gas block support.
 Remove the lid of the receiver.
 Place 4 AA/LR6 Alkaline long life batteries (fig. 2.2).
 Close the lid and replace the receiver set in the gas block support.
FORMA GAS 55/75/95/115
USER MANUAL
Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
3
page