Basic Functions Of The Remote Control Unit; Switching On The Hearth; Adjusting The Flame Height; Switching Off The Hearth - MCZ FORMA GAS 55/75/95/115 Guide De L'utilisateur

7. Basic functions of the Remote Control Unit

7.1 Switching on the hearth

 Press the - key and the
The start-up procedure will be executed now. During this period the receiver will emit a
o
repetitive sound signal.
The hearth will start burning at the highest position automatically now.
o

7.2 Adjusting the flame height

Keep the
o
Keep the
o
pilot light. (fig. 2.0)

7.3 Switching off the hearth


Press the OFF-key and the hearth will be switched off completely. (fig. 1.8)

Move the toggle switch F (fig. 1.2) to position – O, if the hearth is not in use for a longer period.

8. Thermostat and Timer Function

The following settings are possible in the thermostat function:
 Day temperature
 Night temperature
If the thermostat function is used, the remote control unit should be placed in the wall bracket (fig. 2.4/2.5/2.6),
this should be mounted within 4 metres of the hearth in the same room.
The timer function (TIMER) can make the thermostat function once or twice on day temperature and one or
twice on night temperature during a period of 24 hours.
Factory settings thermostat and timer:
Day temperature -
Night temperature -
Timer -
Example setting one switch period:
Day temperature -
Night temperature -
Timer -
FORMA GAS 55/75/95/115
USER MANUAL
-key simultaneously, until a sound signal is audible (fig. 1.7).
-key pushed in to increase the flame height step by step. (fig. 1.9)
-key pushed in to lower the flame height step by step and/or to switch back to the
(TEMP)
(TEMP)
23°
-- (appliance doesn't switch on)
P1  6:00 (getting up)
P1  8:00 (departure)
P2  16:00 (homecoming)
P2  22:00 (night)
21°
-- (appliance doesn't switch on)
P1  8:00 (getting up)
P1  22:00 (night)
Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
5
page