Overview Multigyro G3; Overview Led Display; Features; Technical Data - Multiplex MULTIGyro G3 Mode D'emploi

2. Overview MULTIGyro G3

"IN" area
Flight mode changeover switch
1
Aileron
2
Elevator
3
Rudder
4
"OUT" area
Aileron
5
Elevator
6
Rudder
7

2.1 Overview LED display

Status LED display
Initialisation The blue and red LEDs ash rapidly for three
seconds after switching on the gyro.
Blue LED ashes after initialisation.
Red LED ashes rapidly after initialisation.
Operation Blue LED illuminated permanently.
Red LED illuminated permanently.
Both LEDs are off.

3. Features

· It is possible to toggle between three flight modes while
your model is airborne: 1. Off / 2. Standard / 3. Heading hold
· MULTIGyro G3 supports three model types:
1. Standard aircraft / 2. Delta wing or flying wing /
3. Aircraft with a V-tail
Supported model types:
Aileron servo
1
Elevator servo
2
Rudder servo
3

4. Technical data

Voltage range
PWM output
PWM signal
Full scale range
Model type selection (jumper)
J1 – V-tail
8
J2 – Delta wing or ying wing
9
J3 – Standard aircraft model
10
Gyro gain adjustment
Potentiometer rudder
11
Potentiometer elevator
12
Potentiometer aileron
13
· Specially optimised for 3D flight.
· Independent gyro adjustment and gyro reversing for each
channel.
· Small and lightweight, thus also suitable for smaller aircraft.
1 1
Standard
aircraft
2
3
5 - 6V DC Gyro sample rate
50Hz, or 20ms Operating temperature
1520±500µs Dimensions
970~2070µs Weight
2
1
3
4
5
6
7
8
9 10
LED display
Red LED
14
Blue LED
15
Description
Initialised. Do not move the aircraft until initialisation
has been completed!
Initialisation successful.
Initialisation failed. Unde ned model type. Check the
adjustments J 1-2-3.
Standard mode. Ready for ight.
Heading hold mode. Ready for ight.
Gyro is deactivated. Ready for ight.
Aircraft with
a V-tail
1 1
2 3
1
1KHz
-40°C to 85°C
47 x 33 x 14 mm
11 g
12
11 13
14
15
Delta wing or
flying wing
3
2
9